|
|
T
|
Name
|
Size
|
Created / Uploaded
|
Last modified
|
Files
|
Hits
|
|
|
|
|
|
Battery Etc
|
400.56 KB |
Mon 11 of Nov, 2013 |
Fri 25 of Jul, 2025 |
|
145 |
|
|
|
|
|
Ppg Guages
|
47.71 KB |
Mon 11 of Nov, 2013 |
Fri 25 of Jul, 2025 |
|
130 |
|
|
|
|
|
Meandnewt
|
50.01 KB |
Sat 05 of Dec, 2009 |
Fri 25 of Jul, 2025 |
|
60 |
|
|
|
|
|
Belly Repair
My repair of WR's belly after wheel up landing (not mine).
The large whiter area is new flow coat along with a few small patches of still wet coat where the glass began to show through. The old coat is in bad shape which makes it almost impossible to neatly blend the new layer. |
28.56 KB |
Mon 13 of Oct, 2008 |
Fri 25 of Jul, 2025 |
|
40 |
|
|
|
|
|
Gsp2
|
32.04 KB |
Tue 29 of Apr, 2008 |
Fri 25 of Jul, 2025 |
|
144 |
|
|
|
|
|
Gsp1
|
13.06 KB |
Tue 29 of Apr, 2008 |
Fri 25 of Jul, 2025 |
|
142 |
|
|
|
|
|
Couplings 0296
H’otelier couplings for aileron and air-brake in our LS1f (wr).
These are a bugger to rig because you can't see them and have to do it all by touch.
They require lube every 50 flight hours. |
76.39 KB |
Sun 27 of Apr, 2008 |
Fri 25 of Jul, 2025 |
|
46 |
|
|
|
|
|
Wrtailwheelmnt4
The carbon is now trimmed arounf the sides and the wheel well hole trimmed to match the hole in the rubber (which is uneven and off centre).
A trial fit shows the wheel fits ok. These wheel bearings take a 8mm shaft, I also have some which take 6mm.
|
74.95 KB |
Sat 26 of Apr, 2008 |
Fri 25 of Jul, 2025 |
|
44 |
|
|
|
|
|
Wrtailwheelmnt3
I cleaned up the block and tidied up the slot where the axle goes.
The I made a vacuum infuse carbon fibre cap.
Vacuum infusion info can be found on my main webside - eddie.com |
66.26 KB |
Sat 26 of Apr, 2008 |
Fri 25 of Jul, 2025 |
|
47 |
|
|
|
|
|
Wrtailwheelmnt
This is the side which sees the runway. The steel axle mounting hole is intact on the bottom side of the photo but the other side is broken. |
29.34 KB |
Mon 21 of Apr, 2008 |
Fri 25 of Jul, 2025 |
|
46 |
|
|